Engineering Knowledge
知识中心
Selection, manufacturing, inspection, applications and troubleshooting for spline shaft interfaces.
Backlash in Spline Connections: What It Means and What to Check
Backlash in Spline Connections: What It Means and What to Check — Backlash is rotational clearance between mating spline teeth. It results from the…
Read MoreSpline Fretting: Symptoms, Causes and Design Checks
Spline Fretting: Symptoms, Causes and Design Checks — Fretting occurs when loaded mating surfaces experience very small repeated relative motion. On…
Read MoreWhy Spline Shafts Wear: Common Contact and Alignment Causes
Why Spline Shafts Wear: Common Contact and Alignment Causes — Spline wear is usually a symptom of the complete connection. Misalignment, insufficient…
Read More
Spline Connections in Gearbox Input and Output Shafts
Spline Connections in Gearbox Input and Output Shafts — Gearbox input and output splines must work with the bearing support, seal location, coupling or…
Read MorePTO Spline Interfaces: Tooth Count, Connection and Fit Basics
PTO Spline Interfaces: Tooth Count, Connection and Fit Basics — PTO spline identification starts with the actual mating connection, not only the tractor…
Read MoreSpline Shaft and Hub Matching: A Practical Interface Checklist
Spline Shaft and Hub Matching: A Practical Interface Checklist — A spline shaft and hub must match in tooth system, pressure angle, major and minor…
Read MoreGear and Spline Shafts for Compact Power Transmission Layouts
Gear and Spline Shafts for Compact Power Transmission Layouts — Combining a gear and spline on one shaft can reduce separate joints and axial stack-up,…
Read More
