슬라이딩 및 고정 스플라인 연결부의 윤활 고려 사항
슬라이딩 스플라인 연결부와 고정 스플라인 연결부의 윤활 고려 사항 — 슬라이딩 스플라인 연결부와 고정 스플라인 연결부는 다음과 같은 이유로 윤활 요구 사항이 다를 수 있습니다…
Read MoreEngineering Knowledge
지식센터
Selection, manufacturing, inspection, applications and troubleshooting for spline shaft interfaces.
스플라인 이빨의 홈 및 표면 손상: 검사 가이드
스플라인 톱니의 홈 및 표면 손상: 검사 가이드 — 홈 및 표면 손상은 부품을 세척하거나 폐기하기 전에 기록해야 합니다.
Read More정렬 불량이 스플라인 톱니와 결합 허브에 손상을 주는 방식
정렬 불량은 스플라인 치아와 결합 허브에 손상을 입힙니다. 정렬 불량은 접촉면을 따라 하중을 분산시키는 대신 치아 가장자리에 하중을 집중시킵니다.
Read MoreBacklash in Spline Connections: What It Means and What to Check
Backlash in Spline Connections: What It Means and What to Check — Backlash is rotational clearance between mating spline teeth. It results from the…
Read MoreSpline Fretting: Symptoms, Causes and Design Checks
Spline Fretting: Symptoms, Causes and Design Checks — Fretting occurs when loaded mating surfaces experience very small repeated relative motion. On…
Read MoreWhy Spline Shafts Wear: Common Contact and Alignment Causes
Why Spline Shafts Wear: Common Contact and Alignment Causes — Spline wear is usually a symptom of the complete connection. Misalignment, insufficient…
Read More
Spline Connections in Gearbox Input and Output Shafts
Spline Connections in Gearbox Input and Output Shafts — Gearbox input and output splines must work with the bearing support, seal location, coupling or…
Read MorePTO Spline Interfaces: Tooth Count, Connection and Fit Basics
PTO Spline Interfaces: Tooth Count, Connection and Fit Basics — PTO spline identification starts with the actual mating connection, not only the tractor…
Read MoreSpline Shaft and Hub Matching: A Practical Interface Checklist
Spline Shaft and Hub Matching: A Practical Interface Checklist — A spline shaft and hub must match in tooth system, pressure angle, major and minor…
Read MoreGear and Spline Shafts for Compact Power Transmission Layouts
Gear and Spline Shafts for Compact Power Transmission Layouts — Combining a gear and spline on one shaft can reduce separate joints and axial stack-up,…
Read More
