Selection, manufacturing, inspection, applications and troubleshooting for spline shaft interfaces.
Considérations relatives à la lubrification des assemblages cannelés coulissants et fixes — Les assemblages cannelés coulissants et fixes peuvent avoir des besoins de lubrification différents car…
Read MorePiqûres et dommages de surface des dents cannelées : Guide d’inspection — Les piqûres et les dommages de surface doivent être documentés avant le nettoyage ou la mise au rebut des pièces.
Read MoreComment un mauvais alignement endommage les dents cannelées et les moyeux d'accouplement — Un mauvais alignement concentre la charge sur les bords des dents au lieu de répartir le contact le long de…
Read MoreBacklash in Spline Connections: What It Means and What to Check — Backlash is rotational clearance between mating spline teeth. It results from the…
Read MoreSpline Fretting: Symptoms, Causes and Design Checks — Fretting occurs when loaded mating surfaces experience very small repeated relative motion. On…
Read MoreWhy Spline Shafts Wear: Common Contact and Alignment Causes — Spline wear is usually a symptom of the complete connection. Misalignment, insufficient…
Read More
Spline Connections in Gearbox Input and Output Shafts — Gearbox input and output splines must work with the bearing support, seal location, coupling or…
Read MorePTO Spline Interfaces: Tooth Count, Connection and Fit Basics — PTO spline identification starts with the actual mating connection, not only the tractor…
Read MoreSpline Shaft and Hub Matching: A Practical Interface Checklist — A spline shaft and hub must match in tooth system, pressure angle, major and minor…
Read MoreGear and Spline Shafts for Compact Power Transmission Layouts — Combining a gear and spline on one shaft can reduce separate joints and axial stack-up,…
Read More
